REMOTE CONTROL
Use the remote control within a distance of 20 feet and 180 degree radius to the
front of the AC unit. Point the remote towards the receiver.
Reception is confirmed by a beep.
11
20’
CAUTIONS
· The air conditioner will not operate if curtains, doors or other materials block the signals from
the remote controller to the indoor unit.
· Prevent any liquid from falling onto the remote. Do not expose remote to direct sunlight or heat.
· If the infrared signal receiver on the AC unit is exposed to direct sunlight, the unit may not
respond properly. Use curtains to prevent sunlight from falling on the receiver.
sunlight from falling on the receiver.
· If other electrical appliances react to the remote controller, either move these appliances
or consult your local dealer.
Sleep
Check
Filter
Follow
Me
Auto
On/off
Fan
High
Med
Low
Energy
Saver
on
off
Timer
Auto
Fan
Cool
Dry
Mode
TEMP/TIMER
TEMP/TIMER
Heat
MODE
TIMER
SPEED
ONE
TOUCH
SLEEP
REPLACING BATTERIES
The remote is powered by two AAA batteries (not included) housed in the rear and protected by a cover:
(1) Remove the cover by pressing and sliding off.
(2) Remove old batteries and insert new batteries, placing the (+) and (-) ends correctly.
(3) Replace cover by sliding it back into position.
NOTE: when batteries are removed, all programming are erased. After inserting new batteries, the remote
controller must be reprogrammed.
Function buttons
Push this button to increase the
o O
temperature setting in 1 C/1 F.
o O
The highest setting is 30 C/86 F.
Or to increase time for timer setting.
Push this button to decrease the temperature
o O
setting in 1 C/1 F increments. Lowest setting is
o O
17 C/62 F.
Or to decrease time for timer setting.
Press this button to activate Sleep mode.
This function is available for COOL or AUTO
mode only and maintains the most comfortable
temperature for you.
Operation starts when this button is pressed
and stops when the button is pressed again.
NOTE: Unit will automatically turn on
under Energy Saver mode.
Press to select the fan speed in four steps:
Auto, Low, Med and High.
ON/OFF button
MODE button
Press this button to select the desired operation
mode: AUTO, COOL, DRY, and FAN.
UP button
DOWN button
FAN button
TIMER button
Push this button to activate the "Auto
Start" or "Auto Stop" program.
SLEEP button
MODE
TIMER SPEED
ONE
TOUCH
SLEEP
ONE TOUCH button
Push this button and system will
automatically shift to COOL mode with
auto fan speed. The set temperature
O O
will be 26 C/80 F. Any timer setting will
be cancelled.
(23 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals